Troubleshooting Salt Levels With Your Water Softener in Arizona
To make sure that your water softener is functioning properly, you want to make sure that the salt levels in your water softener are correct. If you find that the salt levels are not going down but the water softener is regenerating, there are a few ways that you can troubleshoot the problem.
- There may be some kind of a mechanical problem with the water softener. Make sure that you don’t have a leaking valve. You can also watch the regeneration process to make sure that it is working correctly, which will help you determine if you need to call a qualified professional to come and fix the system.
- Salt may become solid just above the water level. Brine is water that is saturated with salt and this salt can sometimes create a crusty layer in the tank of your water softener. This hard layer is called a salt bridge, and for your water softener in Arizona to function correctly, you have to break up this layer and remove any large chunks of salt. After that, the water softener should function correctly.
- Salt crystals can cause a residue in the bottom of the tank of your water softener. If this occurs, it can block the flow of water out of the tank and prevent regeneration from occurring. The best way to fix this problem is to empty the water softener and clean it thoroughly, removing any residue in the bottom of the tank.
- The brine refill control could be clogged, and the brine cannot escape the tank. The water softener will register that the levels are correct and will stop the regeneration process.
If you have any questions about your water softener, call a professional to fix the system.